FUDforum
My FUDforum

Home »  » DeviceMaster RTS, Pro and Serial Hub » Comtrol Device Master RTS 1-Port (Configuration)
Comtrol Device Master RTS 1-Port [message #1232] Sun, 12 July 2020 22:48 Go to next message
Woutlaw is currently offline  Woutlaw
Messages: 1
Registered: July 2020
Junior Member
Hello,

I'm wanting to use the Comtrol 1-port device to be able to communicate with a serial device that will be in the field. If the unit is capable of this, how do I configure the unit to communicate with a field device. The device will be installed in a school zone flasher on the street. The RTS unit will be connected to a time clock unit that has a serial port. My customer wants to use their existing city wide network to access their school zone clocks vs. cellular modems which can be pricey. The end user wants to use the desktop software (installed on PC in their Traffic Operations Building) that will communicate with their field time clocks.
Re: Comtrol Device Master RTS 1-Port [message #1237 is a reply to message #1232] Mon, 28 September 2020 08:09 Go to previous message
Kurt is currently offline  Kurt
Messages: 290
Registered: July 2016
Location: Minnesota
Power User
Yes, the DeviceMaster is capable of this. It can communicate via a Com Port on the PC or via TCP/IP Sockets.

Here's a document that describes installation and setup.
https://files.comtrol.com/contribs/devicemaster/help_files/1 206_SW_Instructions.docx

The User Guide is a great resource as well:
http://downloads.comtrol.com/dev_mstr/rts/docs/dev_mstr_inst all_guide.pdf


Kurt Rees
www.comtrol.com
http://forum.comtrol.com/

Comtrol Corporation
100 Fifth Ave NW
Minneapolis, MN. 55112
Direct +1 763.957.6000 | +1 Fax (763) 957-6001
connect. communicate. control
Previous Topic: RTS 8-Port with Modems communicating with alarm panels
Next Topic: Firewall sticky broken
Goto Forum:
  


Current Time: Tue Jun 22 23:44:51 CDT 2021

Total time taken to generate the page: 0.00660 seconds